Laval Concrete Steps & Stairs, Poured Right the First Time
A gap in the riser height or a base that heaves with the frost turns everyday steps into a liability. Laval Concrete pours front-entry steps, landings, and full staircases with equal risers, grip-textured treads, and a compacted base built for Quebec winters. Free written estimate on every job.
Where Concrete Steps Go Wrong, and How We Prevent It
Two things cause most step failures in Laval: unequal risers and a base that was never deep enough to survive frost. Unequal risers are a forming problem, if the total door height is not divided precisely before the forms go up, every tread ends up a slightly different height, and that inconsistency is what catches a foot. We measure the full rise first, set equal divisions, and hold those dimensions through the pour.
The base problem is just as predictable. Shallow fill under a concrete slab compresses and shifts with freeze-thaw cycles, pulling the steps away from the foundation wall. Our foundation installation experience informs how we prep step bases: granular fill, proper compaction depth, and reinforcement through the treads so the nosing does not chip under load.
Finish matters too, especially through a Laval winter. A smooth trowel finish turns slick the moment moisture hits it. We broom or brush the tread surface to give it grip without looking rough, and we tie the bottom step cleanly into whatever decorative walkway or plain concrete path meets it. See our concrete care guide for sealing schedules that extend tread life.
Recent work
How it works
From Site Measure to Finished Concrete Staircase in Laval
On-site measure and layout
We record the total height from grade to the door threshold, calculate equal riser divisions, and mark the run depth so every tread will match before a single form board goes up.
Excavation and base prep
Existing material is removed to a frost-safe depth, granular fill is brought in and compacted in lifts, and the forms are set tight to the house so the finished steps sit flush against the foundation.
Steel placement and pour
Rebar is positioned through the body of the steps and across each tread so the concrete slab carries foot traffic and snow-clearing equipment without cracking at the nosing. The concrete is then poured and consolidated step by step.
Texture, cure, and handoff
Treads are finished with a broom texture for grip, the concrete cures under cover if weather demands it, and we give you a clear date when the steps are ready for full use.
Existing steps shifting
Settled or Cracked? Step Repair That Fixes the Cause, Not Just the Surface
A concrete step that has tilted, cracked along the nosing, or opened a gap against the house wall is telling you something about what happened underneath. Patching the surface without addressing the base just delays the same failure by a season or two. Before any repair work starts, we probe the base to find out whether the fill settled, whether water has been pooling under the slab, or whether the concrete itself has deteriorated.
When the base is still solid, resurfacing and re-levelling is a legitimate fix that saves the cost of a full rebuild. When the base has failed, we say so plainly and quote the rebuild. Either answer comes from the same free site visit. For homeowners planning new construction rather than repair, our front entry steps page covers what a new pour involves, and staircase construction handles multi-flight and landing work. Larger outdoor projects often pair steps with a stamped concrete patio or a poured retaining wall at the same time.
What to know about riser math, base prep, winter grip, and whether your steps need repair or replacement.
Because your feet learn the staircase. A riser that varies between steps is the single most common cause of a stumble, so we measure the total height and divide it into equal risers with a consistent run from bottom to top.
Almost always a base problem, steps poured on a shallow or poorly compacted base heave with frost and settle away from the foundation. Foundation crack repair and proper base depth keep new steps in place.
It depends why they moved. If the base is sound, step repair can re-level and resurface them. If the base failed, rebuilding is the honest fix, and we tell you which one it is on the free visit.
Yes. Staircase construction covers multi-flight stairs and landings, formed and reinforced so the treads and nosings carry load without cracking.
Not when they are finished for it. We give treads a grip texture rather than a smooth trowel finish, and the consistent rise means there are no surprises underfoot when the steps are wet or snow-covered.
Homeowner reviews
What Laval Homeowners Say About Their Concrete Steps
Our old front steps had pulled off the house and every riser was a different height. The new ones are even, solid, and tight to the door. Huge difference walking up.
D. L.
Laval
★★★★★
Poured a full staircase to a raised deck. Reinforced properly, grip-finished treads, and not a wobble anywhere. Looks built to last.
S. G.
Montreal
★★★★★
They re-levelled our settled steps instead of rebuilding because the base was still good. Saved us money and were upfront that it would hold.
C. A.
Repentigny
★★★★★
Entry steps tied straight into the new walkway. Even rise, textured so they are not slippery, and the crew left the site spotless.
T. W.
Terrebonne
From the blog
Concrete Guides & Articles
Practical reading on planning, finishes and caring for concrete in Laval.
Whether you need new front-entry steps poured from scratch, a multi-flight staircase formed and reinforced, or existing steps assessed and repaired, call or submit a request and we will schedule a free site visit. You will receive a written, itemised quote before any work begins.
